Axial AR3 RX problem?

[mcap]

My RX is blinking red slowly. I tried binding the ax3 to it and it won't turn solid red and bind. I can't calibrate my ESC or anything and wondering what's up. Any recommendations or anyone have an axial RX laying around they will sell cheap? Replaced batteries in TX etc...

Thx in advance for assistance

[k7zpj]

Did you use the binding plug on CH3 when you tried to bind to the Tx?

If this is a newer rig, I would call Axial support before buying a new receiver.

The Flysky FS-GR3E reciever will bind to the AX3 radio. You can get them on eBay for 8 bucks with free shipping.

US SHIP Flysky FS GR3E Receiver 3CH Failsafe for Flysky GT2 GT2B GT3 GT3B GT3C | eBay

[mcap]

Hi, yes I did have the bind plug in channel 3 and was holding bind on tx while turning on the transmitter and continued holding it. I just ordered a new radio so will give that a go when it arrives. Just not sure if this is worth keeping. tX powers on and is mint, maybe I should try my luck with the receiver u mentioned

[Charlie-III]

Originally Posted by mcap

Hi, yes I did have the bind plug in channel 3 and was holding bind on tx while turning on the transmitter and continued holding it. I just ordered a new radio so will give that a go when it arrives. Just not sure if this is worth keeping. tX powers on and is mint, maybe I should try my luck with the receiver u mentioned

Try this while binding the RX to TX....... Hold the TX antenna close to/against the RX antenna, sometimes this is required on any brand radio.