Mamba Max Pro

[kgb424]

Got a question for anybody, I bought a used Mamba Max Pro and there is a deans connector on the A wire/red and the C wire/black and the B wire/white is not connected, it setup this way to run a brushed motor on the Mamba Max Pro, I didn't know you could run brushed motors on a MMP.

[gdb85]

Yes you can sir. It's a pretty versatile ESC.

You'll need the Castle link or set up booklet to change it back to brushless.

[Exocaged]

Yep you sure can run a brushed motor on there! The MMP is a very versatile esc.

[B94Cast]

Just a personal safety thing - but run the deans female on the motor output, that way no danger of plugging esc output into a battery during a moment of derp.
Easy way to prevent smoking a nice esc.

[kgb424]

Thanks every one I'm going to run A Tekin 13.5T Redline Sensored brushless motor and going to put the Castle 4mm bullets connectors and 13 AWG wire and make some disconnect leads from the esc to motors, I got two MMP's and two Redlines 13.5T for both of my SCX10's, waiting on my MIPS CVD Center Drive Shaft kits.

[Exocaged]

One thing I've read before about brushless esc's is to cut all the esc output wires to the same length and also the same with the motor wires. I read it had something to do with the phases and different distances can mess things up. Idk how true it is considering how short our wires are but it's something I always do when messing with esc and motor wires.

[scatterbrains]

Cut that plug out and hard wire it to the motor...JMO
They are great esc's

[U F'n A Racing]

I run that exact setup on my exo crawler. Absolutely love it, especially how adjustable everything is. Remember to set your timing on the Tekin to zero. At least that's what I was told to do.

[kgb424]

Well I got every thing soldered up, and shrink wrapped. The one esc with red shrink wrap is factory, so the one in black shrink wrap is the one I done, and leads on both motors, so they are interchangeable between my Scx10's. There both geared with a 32p 60T spur and 32p 9T pinion and are way too slow so going to buy 10T, 11T, 12T, 13T and see I want one with speed and wheel spin, and one with torque and controllability to craw.