|
| LinkBack | Thread Tools | Display Modes |
01-23-2014, 09:59 PM | #1 |
Quarry Creeper Join Date: Oct 2010 Location: denver
Posts: 301
| Speed gem 2 brushed motors
Anyone run these espicaly the sapphire (blue) can. Even if you ran it in a non crawler, how did it hold up? If you had it in a crawler how was wheel speed and what was your gearing?
|
Sponsored Links | |
01-25-2014, 04:01 PM | #2 |
Quarry Creeper Join Date: Oct 2010 Location: denver
Posts: 301
| Re: Speed gem 2 brushed motors
Anyone run these in anything ?
|
01-25-2014, 05:27 PM | #3 |
I wanna be Dave Join Date: Apr 2007 Location: Arlington, Washington
Posts: 2,303
| Re: Speed gem 2 brushed motors
The cans and endbells are good, but the arms are pretty low turns for anything in a crawler. If you swapped in a more crawler friendly armature they work just fine. Most crawler arms fit with no mods... Later EddieO |
Speed gem 2 brushed motors - Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Trinity speed gem 15.5 brushless? | crawlernut | Electronics | 2 | 01-14-2013 06:25 AM |
1/16 e revo brushed speed? | firefightermaness | Non Crawler RC's | 2 | 07-18-2012 08:02 AM |
Speed/Torque difference between Crawler motors/Normal motors? | dynamic_e | Electronics | 5 | 10-08-2010 10:26 AM |
17 turn speed gem? too much? | scorpion_king | Electronics | 6 | 08-09-2007 04:20 PM |
Thread Tools | |
Display Modes | |
| |