dumb LED question I'm sure this will seem like a dumb question and/or has already been covered elsewhere, but I searched and did not find an answer... I'm running stock receivers in both my wraith and my SCX10. I use the Ch3 slot to power my LED's, but is it possible to power another LED string from the bind port (BAT)? I just picked up a light bar for my wraith, and really don't want to splice it in. I'm still new to soldering and its a PITA... |
Yeah any open channel in your receiver will power lights |
Re: dumb LED question Thanks man.. I was really beginning to hope that wasnt too dumb of a question... 58 views and only one response. hahaha... I didn't want to fry the lights trying to figure it out for myself... appreciate the feedback. |
Re: dumb LED question You can also make a "squid" cable. Once connector to the Rx and many connectors on the other end. Very similar to parallel charge cables. |
All times are GMT -6. The time now is 03:34 PM. |
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Content Relevant URLs by vBSEO ©2011, Crawlability, Inc.
Copyright 2004-2014 RCCrawler.com