| |
03-04-2014, 12:07 AM
| #1 |
| Rock Crawler Join Date: Oct 2013 Location: Wiscasset, ME
Posts: 623
|  Screw drive?
Looking for some guidance in regards to making my dump truck bed raise. Tonka dump truck bed on a custom 6x6 frame. I was thinking a motor turning a threaded rod mechanism. I've seen this done in videos and pictures, but No real build thread on it. I've searched for an hour now and i'm giving up for the night. If someone can direct me to a proper picture or build thread i'd really appreciate it! |
|  |
| Sponsored Links | |
| | |
|
03-06-2014, 09:12 PM
| #2 |
| Rock Crawler Join Date: Jan 2008 Location: Lehigh Valley, Pa
Posts: 768
| Screw drive?
Head over to scale4x4rc . Most if the dumps are that way. There are basically two options using a speed control type thing, like a servo motor with a winch control, or some guys are using a simple on off with limit switches. I don't have any experience, so I can't say, but I have been looking at the too. Good luck Last edited by tgh117; 03-07-2014 at 09:54 PM. |
|
| |
 |
Screw drive? - Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Stripped Hex Screw - Craftsman Screw Extractor | bigstu | Tools, and Procedures | 8 | 11-05-2011 08:48 AM |
| Old school tank like thingy (screw drive) | TURTLE | Chit Chat | 12 | 01-07-2010 01:15 PM |
| Integy HD universal Drive shaft grub screw size?? | madmax22 | Axial AX-10 Scorpion | 8 | 08-26-2009 04:19 PM |
| Help - Lost Drive Shaft Screw | BMFOTP | Newbie General | 18 | 04-12-2009 09:30 AM |
| Screw drive line? | username | Newbie General | 5 | 12-14-2008 05:03 PM |
| Thread Tools | |
| Display Modes | |
| |
Linear Mode
