about to place some orders.help!!!!!

[newbiecrawler20]

hey everyone.just like the title says i'm about to be placing some orders to finish up my avalanche build.and want to make sure i'm not wasting money on the parts i'm looking at.

ive already bought these.
turnigy mg959v2 steering servo (on back order)
kershaw designs 14.4 dewalt summit motor

and need advise on these

solar servo d228 servos (for dig and 2 speed)
flysky gt3c (with hack) what 8 channel receiver could i use?
holmes brxl esc
sky 5000mah 30c 14.8 4s lipo
thunder ac6 charger

also how many bec's would i need to run a winch and those three servos?
the two d228s only run 152.9oz.in at 6v

all help is greatly appreciated

[newbiecrawler20]

instead of the solar servos.i went ahead and got 2 hitec 645mg's.now im stumped on all the bec wiring.i believe i need a bec for the winch so i can run it at 7.2 volts not 6v.but i dont know if ill need one for the 3 servos or what.will i need to run one direct to the steering servo? and and let the brxl run the shift and dig servos?

[offroadjeepin]

Theres a great sticky on BEC's. But I will say you probably need a castle BEC pro or similar to run servo and winch

[newbiecrawler20]

hey thanks for the reply .ill check into the bec pro.im just trying to figure out out these electronics

[offroadjeepin]

I would also suggest a HeyOk winch controller. Check vendors section