RCCrawler Forums

paieste · 08-20-2014, 05:38 PM

Hi everybody have had this setup for quite a while but now I want to run a servo from my 3rd channel. Problem is that plugged everything right (I think) pluged the servo on the 3rd channel (acc.) and enabled the 3pos switch on the dx3c and rebind everthing but it does not work. Switched my steering servo still nothing. So I am sure my 2 servos are working. Same thing when I do it for 2pos switch. What could be the problem? If I enable the switch let's say for steering rate it works like it is suppose to. Any help would be great!

paieste · 08-20-2014, 08:22 PM

Bump... Anybody? I am sure lot's of people here run this transmitter

08-20-2014, 05:38 PM	#1
paieste Newbie Join Date: Aug 2014 Location: Quebec Posts: 5	Help needed with Spektrum dx3c & sr300 (2 & 3 position switch) setup. Hi everybody have had this setup for quite a while but now I want to run a servo from my 3rd channel. Problem is that plugged everything right (I think) pluged the servo on the 3rd channel (acc.) and enabled the 3pos switch on the dx3c and rebind everthing but it does not work. Switched my steering servo still nothing. So I am sure my 2 servos are working. Same thing when I do it for 2pos switch. What could be the problem? If I enable the switch let's say for steering rate it works like it is suppose to. Any help would be great!

08-20-2014, 08:22 PM	#2
paieste Newbie Join Date: Aug 2014 Location: Quebec Posts: 5	Re: Help needed with Spektrum dx3c & sr300 (2 & 3 position switch) setup. Bump... Anybody? I am sure lot's of people here run this transmitter

Sponsored Links

RCCrawler Forums

Thread: Help needed with Spektrum dx3c & sr300 (2 & 3 position switch) setup.