|
| LinkBack | Thread Tools | Display Modes |
10-08-2014, 06:21 AM | #1 |
Newbie Join Date: Nov 2012 Location: Australia
Posts: 39
| Wiring vanquish light bar
Hi guys I'm putting a vanquish light bar on my scx10. The bar will be mounted on the body. I want to wire it to a switch mounted on the body then have a connection so I can take the body off. then run the power from the esc side of the battery plug to the connection near the switch. Will that work?
|
Sponsored Links | |
10-08-2014, 06:56 AM | #2 |
Pebble Pounder Join Date: May 2013 Location: Lees Summit
Posts: 139
| Re: Wiring vanquish light bar
The Vanquish light bars run on 11.1v or 3s LiPo. What I did, and it works but may not be the best way, was ran the positive to an SPST switch, out of the switch to the positive side of a deans connector. The negative just run straight to the deans. Then just plug the deans direct into a small 1600mah 3s battery. It works and I now have a switch mounted in the drivers seat...between the drivers legs |
Wiring vanquish light bar - Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
G6 light bar wiring job | uclabruins89 | Axial SCX-10 | 7 | 01-23-2015 10:48 AM |
Wiring light bar. | 355C | Newbie General | 3 | 01-31-2014 11:20 AM |
Maddog LED light bar wiring | Jbtamu1011 | Electronics | 6 | 01-21-2014 05:05 PM |
Axial 5-light universal light bar wiring question... | KillerBlackbird | Axial Wraith | 9 | 11-28-2012 06:18 PM |
| |