12-27-2014, 06:56 PM | #1 |
RCC Addict Join Date: Nov 2009 Location: New Wilmington, PA
Posts: 1,234
| DX4c and a winch
Just got a DX4c and I'm trying to get it to work with my Heyok relay winch controller. I set my ch3 to 3 pos but it seems to be set for 0/1/2 rather than -1/0/1. I have seen someone do it on a youtube vid, but I can't figure it out. |
Sponsored Links | |
12-27-2014, 07:46 PM | #2 |
RCC Addict Join Date: Nov 2009 Location: New Wilmington, PA
Posts: 1,234
| Re: DX4c and a winch
nevermind, I got it. setup ch 3 as 3rd pos, and go to mixing and setup aux1 to mix with aux 1, and set active to trim. |
12-27-2014, 08:17 PM | #3 |
Quarry Creeper Join Date: Nov 2013 Location: lethbridge,alberta, its mighty windy here!!
Posts: 234
| Re: DX4c and a winch
just curious why do you need to use a mix, im using a dx4c and have been for a while and have not needed to use any sort of mixing to get either of my aux channels to act correctly as a 3pos type for winch control or anything else.
|
12-28-2014, 06:20 AM | #4 |
RCC Addict Join Date: Nov 2009 Location: New Wilmington, PA
Posts: 1,234
| Re: DX4c and a winch
Not sure why it wouldn't work, maybe because I was using a relay switch?
|
12-28-2014, 09:58 AM | #5 |
Pebble Pounder Join Date: Jun 2013 Location: West Jordan, Utah
Posts: 129
| Re: DX4c and a winch
My lil bro has to reset his dx4c every time he runs his scx10 for using his winch. Resets the channels. Lhs said just to do it each time... Should I contact horizon?
|
DX4c and a winch - Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Spektrum dx4c help!! | JDBuilt | Paint and Body | 2 | 12-04-2014 01:13 AM |
Spektrum dx4c help!!! | JDBuilt | Electronics | 0 | 11-24-2014 07:37 PM |
DX3C vs DX4C | cmbscx10 | Electronics | 4 | 11-10-2014 01:10 AM |
| |