How many ohm potentiometer for servo? Any of you electrical engineers out there know how many ohm's I need for a standard 5-6v servo's potentiometer? The potentiometer in my Hitec 645mg broke from using too long of a servo horn screw so I'm going to try and replace it, but I don't know how many ohms are necessary. Thanks in advance! :) |
Re: How many ohm potentiometer for servo? it should be ink stamped somewhere on the pot body where the shaft exits, im pretty sure the ones i have removed have been 5k ohm. tony |
Re: How many ohm potentiometer for servo? Quote:
|
Re: How many ohm potentiometer for servo? no problem, hopefully that should be in the ballpark area. im sure the last hitec i took apart had the 5k pot and was marked but if not we can resort to a multimeter if needed. |
All times are GMT -6. The time now is 02:22 AM. |
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Content Relevant URLs by vBSEO ©2011, Crawlability, Inc.
Copyright 2004-2014 RCCrawler.com