Need a larger "receiver" box...
 

Howdy, what do you guys use for boxes? I have an SCX box in the rear of my wraith for electronics-receiver, led light control, and an led light switch, and it's damn full! The rear of the truck is open and I'm looking for a larger box that isn't a rubber made sandwich container, any ideas??

Re: Need a larger "receiver" box...
 

Here is what I use:
Project Enclosure (4x2x1) : Project Boxes | RadioShack.com
Project Enclosure (3x2x1) : Project Boxes | RadioShack.com

Re: Need a larger "receiver" box...
 

x2 on the radio shack hobby boxes....... Have used in past and are great

Me personally I conformal coat everything....... Shrink wrap and run it. I end up with very little room for any boxes.

Re: Need a larger "receiver" box...
 

Good stuff guys, thanks! I think I'll give the radio shack box a try.

Re: Need a larger "receiver" box...
 

I've also used the project boxes in two rigs with no problems. I used a dremel to make room for the exiting wires near the top, then used silicone around the wires and around the entire lid.

Re: Need a larger "receiver" box...
 

You could try any nitro buggy radio boxes as they have room for Rx and 5cell batteries. Most are at least water resistant....