Hobbywing stock combo esc settings
 

Hi,

I'm new to crawling and i have just built the Vaterra K-5 Blazer Ascender i have put the hobbywing stock combo in which has a 21.5T sensored brushless motor and the juststock club spec esc. I was wondering what settings to set the esc at eg drag brake, start mode(punch), initial brake force and neutral range.

Re: Hobbywing stock combo esc settings
 

These are mostly personal preference.
Drag brake stops the truck when you let off the throttle. If you want it to stop / hold very suddenly and with great force, choose a higher setting. If you want a gentle coasting, choose a low number.

Punch determines how much force is used on startup. So if you want a smooth takeoff choose a higher number? If memory serves 0% is full punch. Good for wheelies in basher trucks.

Initial brake force, I usually leave this alone and let it default to drag brake. Haven't experimented with this much. Others might be more helpful.

Neutral zone, I typed out a response for this, but my brain isn't turned on yet. So google it or search it on the forums.

These are all probably covered a million times, with greater detail.
Also if you hook up your ESC to your PC via the program card, it gives a description of what you're changing.

Re: Hobbywing stock combo esc settings
 

Thanks for that.

Re: Hobbywing stock combo esc settings
 

I run 40% drag on the 10BL60 Hobbywing. With a ROC412 2300kv...

I burned the Justock ESC after 30min with a error on my part... or not I will never know...
I had trouble with the sensor from day 1... but the 10BL60 is flawless ( and nearly the same ESC)

Re: Hobbywing stock combo esc settings
 

Thanks