Axial Wraith AE-2 ESC problem My wraith's ESC constantly goes into program mode without holding throttle on transmitter. Installed CC BEC Pro 2 weeks ago and everything has been working great until now. I triple checked throttle setting to make sure they are set at zero. I even checked all connection between reciever, ESC and CC BEC Pro. Any ideas? |
Re: Axial Wraith AE-2 ESC problem Have you tried re binding the radio to the receiver? |
Re: Axial Wraith AE-2 ESC problem Yes but same result. |
Re: Axial Wraith AE-2 ESC problem Also check your trim and subtrim (if your radio has that) settings to make sure they are zero'd. |
Re: Axial Wraith AE-2 ESC problem Yep triple checked that. |
Re: Axial Wraith AE-2 ESC problem What radio are you using? does it have a 50/50 and 70/30 setting on the trigger? Try a different radio. If your esc is constantly going into program mode, it is sensing a full throttle input from your radio. If a different radio doesn't work remove the BEC and try again. Still not working, probably the ESC. |
Re: Axial Wraith AE-2 ESC problem I only have the factory ax3 2 channel radio that comes with it. |
Re: Axial Wraith AE-2 ESC problem Then, it is highly feasible that the radio is giving a false signal but it is hard to say unless you start isolating parts. |
Re: Axial Wraith AE-2 ESC problem do yo have a spare servo you can try? A bad servo can cause all sorts of stupid problems. Mine would randomly shut the motor down but would still have steering. |
Re: Axial Wraith AE-2 ESC problem No I don't have a spare servo. Got back into rc 2 months ago and money has been fight. |
Re: Axial Wraith AE-2 ESC problem Just un plug the servo and see if it fixes it. |
Re: Axial Wraith AE-2 ESC problem Just tried without servo and still goes into setup mode |
All times are GMT -6. The time now is 04:24 PM. |
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Content Relevant URLs by vBSEO ©2011, Crawlability, Inc.
Copyright 2004-2014 RCCrawler.com