flysky GT3C battery low signal problem

[allanon1965]

i did a short search on google about this and didnt find anything, the transmitter charges the battery up full, (1200mAH) I turn it on and start running my rig, within 3 minutes the low voltage alarm is going off...reading 3.8v.... I have tried 3 new batteries, 2 800's and 1 1200.... any ideas?

[CODYBOY]

Originally Posted by allanon1965

i did a short search on google about this and didnt find anything, the transmitter charges the battery up full, (1200mAH) I turn it on and start running my rig, within 3 minutes the low voltage alarm is going off...reading 3.8v.... I have tried 3 new batteries, 2 800's and 1 1200.... any ideas?

Have you checked the batteries with a volt meter to see what the voltage out put is. You may need to recalibrate the voltage reading on your radio????

[allanon1965]

i have checked the batteries and they are reading correctly, its the radio thats not reading correctly... I will read the manual again and see if there is a calibration for the voltage..

[allanon1965]

well, how do you calibrate the radio for reading the proper voltage? didnt even know that was necessary... its getting very annoying now, almost to the point of chucking this thing for a different radio... anyone have any ideas?