Can't see CC BEC with computer So I was able to program my BEC fine the other day. I set it to 7.4v saved the changes and went on my way. I tried to access it last night and Castle Link can't see it. I tried two different Castle Link plugs and USB cords. I can see my MMP fine with both. I did test my voltage at the bec and it's putting out 7.3v but I am getting some steering servo stall that happens as as the pack starts to discharge. Time for a new BEC? |
Re: Can't see CC BEC with computer Try to plug it in different ways first link to computer then bec if that dont work do link to bec then computer you may need the battery plugged in sometimes that helps. Whats the setup does the light on the receiver go out when it stalls? |
Re: Can't see CC BEC with computer Quote:
|
Re: Can't see CC BEC with computer When the computer USB port cannot supply enough voltage for the Castle Link to function properly, you may need to hook it up to a battery for a power supply. |
Re: Can't see CC BEC with computer I just plug a battery in, even before I know if I need it. Then plug in the Link. Only time it hasn't worked was with a failed Castle link. Cable was good but the board was dead. |
All times are GMT -6. The time now is 03:34 PM. |
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Content Relevant URLs by vBSEO ©2011, Crawlability, Inc.
Copyright 2004-2014 RCCrawler.com