| |
02-06-2016, 09:40 AM
| #1 |
| Newbie Join Date: Feb 2015 Location: Rogue River
Posts: 37
|  Motor winding problems
I just wound my 2nd and 3rd motors and both of them I finished and when hooked to power nothing happened. If I twisted the shaft to get it going it would work but then you stop it and would have to twist it again to get it going. What would be my problem there? |
|  |
| Sponsored Links | |
| | |
|
02-06-2016, 10:42 AM
| #2 |
| owner, Holmes Hobbies LLC   Join Date: Nov 2004 Location: Volt up! Gear down!
Posts: 20,290
| Re: Motor winding problems
post pics of the comm. Either you have a bad comm connection or a short.
|
|
| |
|
02-06-2016, 12:17 PM
| #3 |
| Newbie Join Date: Feb 2015 Location: Rogue River
Posts: 37
| Re: Motor winding problems
Thank you. It was a bad comm connection. Soldered the connection and works great.
|
|
| |
 |
Motor winding problems - Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| winding a motor | JohnRobHolmes | Electronics | 259 | 03-28-2017 10:45 PM |
| Motor winding question | shoptech | Newbie General | 3 | 06-28-2011 08:20 PM |
| Winding a motor | lt99ls1 | Tennessee | 3 | 03-06-2010 07:47 AM |
| Motor winding... | DaViolentOne | Electronics | 5 | 04-23-2008 08:39 AM |
| winding a motor? | tjarr001 | Electronics | 5 | 03-14-2007 02:06 PM |
| |
Linear Mode
