Go Back   RCCrawler Forums > RCCrawler General Tech > Electronics


Thread: Holmes BLE Pro, Puller Pro, SHV500 settings

LinkBack Thread Tools Display Modes
Old 06-11-2017, 11:18 AM   #1
Join Date: Jun 2017
Location: South Jordan
Posts: 23
Default Holmes BLE Pro, Puller Pro, SHV500 settings

Total newb here. I've done quite a bit of reading on the forum and I am impressed with the depth and breadth of knowledge here.
I have hit a point where I have a few questions I can't find conclusive answers to. I'm building an RR10 based around Holmes Hobbies electronics. I've got a BLE Pro, a Puller Pro 3500kv standard, and an SHV500 for steering. I'm also going to run the Axial 2-speed kit, powering the shift servo through a Castle BEC.

Could you folks comment on the ESC settings? Based on comments I've found here on the forum, I'm starting with the following:

Auto LiPo @ 3.2v
Crawler Reverse
Brake 50%
Drag 30%
Max forward 100%
Max reverse 30%
Punch 30%
Start power Medium
BEC 5.5v
Arming time 1.5s
Throttle dead band Average
Sensorless timing Normal (10)
Motor type Smart Sense Brushless
Throttle and brake curves exponential

Any recommendations different than above, considering that I'll be running the 2-speed tranny?

Also, I'm assuming the internal BEC voltage setting should be left at default (5.5v) because the SHV500 powers direct from the battery and the shift servo is running on the external BEC? I'm running a Futaba RX. Any reason to change the ESC BEC voltage?

Thanks for your time.
Hazenhart is offline   Reply With Quote
Sponsored Links

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is On
Trackbacks are On
Pingbacks are On
Refbacks are On

All times are GMT -6. The time now is 09:44 PM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2020, vBulletin Solutions, Inc.
Content Relevant URLs by vBSEO ©2011, Crawlability, Inc.
Copyright 2004-2014 RCCrawler.com