05-17-2018, 02:19 PM | #1 |
Rock Crawler Join Date: May 2018 Location: USA
Posts: 792
| Servo issue?
Hey folks, I was setting my castle link for my new Savox servo and I noticed that if I kept going back and forth between left and right very quickly it would end up stopping and then doing a few turns back and forth before functioning properly. Is it because Im going to fast and confusing the controller inside it? Is this brown out??? I have the 10a castle BEC on it and I run 2s. Its a HV servo.
|
Sponsored Links | |
05-17-2018, 03:54 PM | #2 |
Rock Crawler Join Date: May 2016 Location: SoWIs
Posts: 618
| Re: Servo issue?
That's a brown-out, the RX is resetting. I'd recommend using a bypass for your bec/servo and letting the ESC power the RX. It may not be dropping voltage but could get noisy, so a glitch buster might also help. OR just not stressing it beyond normal usage, lol.
|
05-17-2018, 04:44 PM | #3 | |
Rock Crawler Join Date: May 2018 Location: USA
Posts: 792
| Re: Servo issue? Quote:
| |
Servo issue? - Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Servo issue? | rockpunisher | Electronics | 4 | 04-10-2016 02:16 PM |
Servo issue | 09 Screw | Axial Wraith | 1 | 03-09-2014 01:21 PM |
servo issue | ax10tn | Axial XR10 | 15 | 04-28-2012 07:20 AM |
servo issue | jetrod7024 | Team Losi Comp Crawler | 1 | 03-19-2011 11:27 AM |
servo issue | chuck-biscuits | Electronics | 2 | 03-08-2005 06:45 AM |
Thread Tools | |
Display Modes | |
| |