12-27-2018, 08:54 PM | #1 |
Newbie Join Date: Dec 2018 Location: Austin
Posts: 3
| Yeti
Can I safely run mamba x with castle 1410 motor in my yeti? Sent from my SM-G930VL using Tapatalk |
Sponsored Links | |
12-28-2018, 02:13 AM | #2 |
RCC Addict Join Date: Jun 2016 Location: Germany
Posts: 1,364
| Re: Yeti
I had a 1410 3800 KV 5mm unsensored in mine, paired with a Monster x. And it was fine. I only changed motor cause it was unsensored. Should be fine with a Mamba x also. I could gear mine up to 64/19 on 3s with no issues. And my Little Monster weights approx 10 lbs. Gesendet von meinem Pixel 2 XL mit Tapatalk |
12-30-2018, 07:21 PM | #3 |
Newbie Join Date: Dec 2018 Location: Austin
Posts: 3
| Re: Yeti
Thanks brother a big help. I'm getting a lot of heat out of mine after just a minute or so Sent from my SM-G930VL using Tapatalk |
12-30-2018, 08:36 PM | #4 |
I wanna be Dave Join Date: Feb 2017 Location: My mothers basement
Posts: 2,128
| Re: Yeti
If it's hot: 1) check running gear for binding bearings and overtight gear mesh. 2) if not binding get smaller pinion. |
12-30-2018, 08:46 PM | #5 |
Newbie Join Date: Dec 2018 Location: Austin
Posts: 3
|
Thanks. Running 2s 500mah 30 c. Getting hot fast. 19/64 opinion and spur. Gears all seem good in tranny Sent from my SM-G930VL using Tapatalk Debating on going with holmes puller pro or puller pro xl....thought? Sent from my SM-G930VL using Tapatalk Its clogging in reverse too Sent from my SM-G930VL using Tapatalk Last edited by THX_138; 12-31-2018 at 09:09 AM. Reason: Merged... posts a minute apart |
12-31-2018, 12:07 AM | #6 | |
I wanna be Dave Join Date: Feb 2017 Location: My mothers basement
Posts: 2,128
| Re: Yeti Quote:
maybe find some bearings to oil, that's really the only thing that wears out in the motor, replace them and good as new. | |
12-31-2018, 07:13 AM | #7 | |
RCC Addict Join Date: Jun 2016 Location: Germany
Posts: 1,364
| Re: Yeti Quote:
Nice options i changed to the puller pro R 540-L I forgot to mentioned i have the 2 speed option in mine also i have installed the included cooling fan on my 1410. But booth are great motors for the yeti and i would consider to change to 3s. i power mine with 5800mAh 65C 3S zippy compact lipo's. (if it's not a typo500mAh is a little small) | |
Yeti - Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Life of one YETI - Tom Frajer's Axial Yeti build log | TomFrajer | Axial Yeti | 320 | 05-22-2017 09:01 PM |
Yeti, Set, GO!!! FastEddy Bearings for the Axial Yeti | FastEddy | Axial Yeti | 13 | 04-21-2015 07:33 AM |
| |