Scx10ii electrics
 

Just about to start build and want to feed 7.4v direct into my savox 35kg hi servo. Problem is my rx I believe is only rated for 6v! Can just run positive and negative wire from servo into main Battery feed and the signal wire into the receiver steeringg channel?
I also considered a cc bec but assume that would push 7.4v into receiver before going out to servo?
Any advice appreciated

Re: Scx10ii electrics
 

get a castle bec an programer u will b able to set the voltage as for wireing the bec tap into the batt plug an the to the pos an neg wire on servo the white wire goes to reciver what savox servo did ya get

Re: Scx10ii electrics
 

Along with the Castle BEC you need the Holmes bypass adapter with will simplify your wiring.

https://holmeshobbies.com/electronic...s-adapter.html

Re: Scx10ii electrics
 

sorry for the late reply, that's great info thanks

Re: Scx10ii electrics
 

Very good plan!

This kind of restates what you wrote:
http://www.rccrawler.com/forum/elect...ml#post5163234