|
| LinkBack | Thread Tools | Display Modes |
03-15-2019, 03:14 PM | #1 |
Newbie Join Date: Jan 2019 Location: US
Posts: 1
| DX5c Losing reverse, need help??
I am running a Mamba x and 2850 slate, Spectrum Dx5c RX TX, Savox 1290sg servo, and a RC4WD Winch and wired controller. After running for a little while I will lose reverse at the Radio. When I switch to monitor the radio output ( on the spektrum radio) it shows that reverse is reading at -4 to -6, essentially no reverse. To correct I have to reset the model and re-bind, then all works correctly again. I think the RC4WD wired controller is causing interference?!?!?!? |
Sponsored Links | |
03-17-2019, 09:53 AM | #2 |
Quarry Creeper Join Date: Aug 2014 Location: Glendive, Montana
Posts: 322
| Re: DX5c Losing reverse, need help??
What button are you using to control your winch? I had a problem where the button i assigned to use with my winch was also set for brake adjust from the factory. It would make me lose reverse in my situation. I have seen a few other people with this issue to.
|
Tags |
dx5c, electronics, reverse, technical |
DX5c Losing reverse, need help?? - Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Spektrum dx5c | wcdfmt510 | Electronics | 11 | 08-22-2021 10:39 PM |
DX5C Receivers | joshiepoogoose | Electronics | 3 | 01-23-2019 02:50 PM |
Did I get a bad DX5C?? | skybolt | Electronics | 20 | 09-22-2018 09:53 AM |
Dx5c with avc | DKOR | Electronics | 14 | 04-06-2018 12:20 PM |
DX5C Settings ?? | Browneye | Electronics | 3 | 12-31-2017 02:40 PM |
| |