04-09-2019, 09:08 PM | #1 |
Pebble Pounder Join Date: Dec 2016 Location: Springville
Posts: 142
| DX5c Newb Question
When assigning an AUX port to a button, what does the settings Cyclic and Momentary mean? Also Linear? 2nd question. I have two speed tranny with low, neutral, and high. What settings would I use for that AUX port to shift between the three modes? I assume 3 position switch, but what else? Thanks! |
Sponsored Links | |
04-09-2019, 09:20 PM | #2 | |
Quarry Creeper Join Date: Apr 2018 Location: US
Posts: 364
| Re: DX5c Newb Question Quote:
Momentary means it will go back to starting position when you release it. Not exactly sure on the linear. Yes the tranny will need a 3 position setup. Sent from my Pixel 2 using Tapatalk | |
04-10-2019, 11:49 AM | #3 |
I wanna be Dave Join Date: Feb 2017 Location: My mothers basement
Posts: 2,128
| Re: DX5c Newb Question
Linear means it has like 100 steps instead of 3. Would be good for using the aux wire with drag brake. Generally you would leave momentary off for a 2 speed transmission or aux wire. You could use momentary with a winch controller. |
04-10-2019, 12:07 PM | #4 |
I wanna be Dave Join Date: Jun 2017 Location: Humboldt county
Posts: 4,482
| Re: DX5c Newb Question
You'll need to use cyclical and 3 position switch for your (3 position) 2 speed. Your AUX travel will set the low and high and the AUX sub trim will be the value for neutral, though this order will depend on the order your tranny shifts in.
|
DX5c Newb Question - Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Dx5c question | AWraith build | Electronics | 11 | 07-09-2021 11:23 PM |
Newb question | rcjeeper | Venom Creeper | 13 | 06-02-2010 08:39 PM |
not a newb but have a question of newb stature | Brandon88 | Electronics | 11 | 04-14-2010 08:53 PM |
Newb question to beat all newb questions | vinster888 | Newbie General | 3 | 12-29-2009 07:24 PM |
| |