Go Back   RCCrawler Forums > RCCrawler General Tech > Electronics
Loading

Notices

Thread: NIMH pack charging not in one go -question

Reply
 
LinkBack Thread Tools Display Modes
Old 04-12-2019, 03:42 AM   #1
Agr
Newbie
 
Join Date: Dec 2009
Location: Amsterdam
Posts: 9
Default NIMH pack charging not in one go -question

Hi, Thanxs for all the info, I've read quite a lot - and still has my question, so here goes:
- I have a old'ish Orion NiMH Rocket Pack2 5100mAh 7.2V stick, it was forgotten for years (so probably dead).
- I have also an Orion IQ605 charger. Set at NiMH, cutoff at 5000mAh, charging slowly for now 0.5A (batteries remain cool to touch)

I will have to break the charge into two or three sessions.
Do I need to keep track of the sesisons I have already charged it, to know when it is supposed to be fully charged after 3 or four charge sessions? or does this charger measure when the battery is full.

For this charger, I do not know if the "Full" / "End" message is only time / charge-capcity driven or if it is measured.

Any advice would be welcome. (Oh, no i will not switch over to LiPo yet), first need to get into it again (still a rookie)
thanxs
Agr is offline   Reply With Quote
Sponsored Links
Old 04-12-2019, 12:13 PM   #2
I wanna be Dave
 
Join Date: Feb 2017
Location: My mothers basement
Posts: 2,128
Default Re: NIMH pack charging not in one go -question

The 5000mAH limit is per charge session. So it's not working on multiple sessions. This is usualy a fail safe if there is a bad cell it can take the current and turn it into heat. So if the battery is bad it will take more mAh than it is rated for but get really hot.

.5amps will take 10.2 hours to charge your battery if it was dead. Dead might not be 0 volts. Usualy it's 5100 usable mah, but that's lipos.

You can Google the manual but just looking at the thing (since it charges lipo's) I assume that it detects voltage while it charges and will automatically shut off if set to nicad 6cell.

You can gradually increase the amperage until you can feel it get warm or you reach the max recomendation charge rate. I don't know what that is for nicads though.

Myself I use lipos, and when they get a little puffy at about 1 year I give them to people who are bolder then me for free.

I don't really have experience with nicads much past charging AA batteries on my hobby charger.
Voodoobrew is offline   Reply With Quote
Old 04-13-2019, 02:36 PM   #3
I wanna be Dave
 
Join Date: Feb 2009
Location: Detroit
Posts: 2,075
Default Re: NIMH pack charging not in one go -question

I would either make the switch to lipos, or buy a new NIMH battery. Charge at a 1c rating. For example 5000mah.. Is 5a charge rate.

Personally, even if you are a rookie, switch to lipo.

Dont charge that old battery. Not worth the risk. If it was a lipo though, i could walk you through bringing it back to life. A lipo is less dangerous than a NIMH battery these days. Trust me.

Sent from my LGMP260 using Tapatalk
CM9000 is offline   Reply With Quote
Reply

Tags
nimh iq605



NIMH pack charging not in one go -question - Similar Threads
Thread Thread Starter Forum Replies Last Post
Noise when charging Nimh? Deezul Electronics 23 09-08-2008 09:39 PM
Quick Saddle Pack Charging Question goldmember Newbie General 5 07-30-2008 09:53 AM
New battery pack - charging question SeanD Electronics 15 04-24-2008 01:59 PM
New pack/charging question 85mudblazin Electronics 4 11-11-2006 04:00 PM

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is On
Trackbacks are On
Pingbacks are On
Refbacks are On



All times are GMT -6. The time now is 07:29 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Content Relevant URLs by vBSEO ©2011, Crawlability, Inc.
Copyright 2004-2014 RCCrawler.com