Tactic tr325 Hello i run axial scx10.2. I have tactic tr325 receiver and tactic ttx200 controller. All of the sudden it stopped working... no throttle, no steering receiver doesnt blink, it makes only two beeps when powered on instead of three beeps. When trying to bind the controller again, it doesnt work. Reciever wasnt in contact with Water... Any ideas? |
Re: Tactic tr325 Quote:
|
Re: Tactic tr325 Try recalibration not re binding..... Hang up and Drive |
Re: Tactic tr325 Your ESC may be dead, what is it? Sent from my SM-G960W using Tapatalk |
Re: Tactic tr325 Quote:
|
Re: Tactic tr325 Quote:
|
Re: Tactic tr325 Quote:
|
Re: Tactic tr325 Esc powers the reciever. Try unplugging and replugging esc wire in reciever, may be it came loose. Sent from my SAMSUNG-SM-G920A using Tapatalk |
Re: Tactic tr325 Quote:
|
Re: Tactic tr325 First Test the battery or replace it with a known fresh charged Second are you running 3s, as you mentioned 3 beeps. What ESC are you powering? is polarity correcton rx(brown wire is ground) Channel 1 is to steering servo, channel 2 is for throttle. Make sure both brown?black wires are in the negative slot |
Re: Tactic tr325 Is your transmitters throttle trim set in the middle? Sent from my SAMSUNG-SM-G920A using Tapatalk |
Re: Tactic tr325 I have not had a ttx 200 only the ttx300. But when my receiver went out, it had a solid red light, no noises. The problem is probably not throttle trim, throttle trim issues I have not seen effect steering. I believe the 2 beeps you hear are coming from the ESC and not the receiver. the esc beeps according to the voltage not the receiver, as the receiver runs off a bec that is usually a lower voltage then 2s. Are there any lights on the receiver? cant find mine at the moment |
Re: Tactic tr325 I got it guys..... Problem is with the stock servo. As soon as i disconnect the driving servo throttle start working... I found some guys experiencing the same peoblem. After replacing servo the problem was solved.. "thumbsup" |
Re: Tactic tr325 Quote:
Quote:
Quote:
Quote:
|
All times are GMT -6. The time now is 05:51 PM. |
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Content Relevant URLs by vBSEO ©2011, Crawlability, Inc.
Copyright 2004-2014 RCCrawler.com