Originally Posted by jessejoe23 (Post 5965548)

Ive been out of crawling for several years. Back when I was in it hardcore, I ran Castle Mamba Max Pro esc. I waterproofed it and beat the daylights out of it,running an 18.5T sensored brushless on my scaler. Id submerge it under water and keep right on crawling,run pack after pack (3s 2200) without it getting hot. Whats newer escs are out there that can compare and take a beating? Im not gentle on my crawlers, I beat them like its part of there job and need electronics that can handle it with minimum maintenance.

Thanks

RC

Originally Posted by brimdogg (Post 5965550)

Mamba X. Add a bit of dielectric grease where the harness plugs in, and remove the power switch (cut and solder the wires together).

Sent from my Pixel 2 using Tapatalk

Originally Posted by jessejoe23 (Post 5965552)

Thanks Ill take a Look, Do you know if they use the castle link like the mmp did?

Originally Posted by durok (Post 5965551)

Castle Creations Mamba X... (i have and use this one myself)

https://www.rpphobby.com/product_p/cse010-0155-00.htm

Tekin RX4 Hardbox... (pricier, but also recommended)

https://www.rpphobby.com/product_p/tektt2000.htm

Originally Posted by jessejoe23 (Post 5965552)

Thanks Ill take a Look, Do you know if they use the castle link like the mmp did?

Originally Posted by jessejoe23 (Post 5965554)

Ive always been a fan of the castle esc. Ill be running a Savoxx High torque steering servo, Im assuming ill still need to run an external BEC?

Originally Posted by brimdogg (Post 5965558)

The Mamba X has a 8A BEC, so it can handle most servo loads no problem.

Sent from my Pixel 2 using Tapatalk

Originally Posted by Jim85IROC (Post 5965561)

Mamba X is the only correct answer.

The Aux feature alone makes it worth it. It's the only ESC I use on my brushless crawler/trail/Rock Racer type vehicles.