| |
| |||||||
 |
| | LinkBack | Thread Tools | Display Modes |
09-30-2019, 02:32 AM
| #1 |
| Newbie Join Date: Jul 2009 Location: Misano Adriatico, Italy
Posts: 13
|  Any info out there about rewinding mass produced 540 motors?
I've recently installed both a 27T and a 55T motor in my scale crawler, the result being one is too fast and the other is too slow. Therefore, instead of messing about, and also because I like to mess about, I was wondering if there was any info out there about rewinding factory produced 540 brushed motors. I want to experiment with that mid-point at around 35-45 turns so are there any guides about wire selection, winding methods etc? Cheers, Tom. |
|  |
| Sponsored Links | |
| | |
|
09-30-2019, 06:08 AM
| #2 |
| RCC Addict Join Date: Jun 2017 Location: Canada
Posts: 1,742
| Re: Any info out there about rewinding mass produced 540 motors?
If it's a sealed can, the answer is most likely no. And you can buy a 540 35T for 20$... Sent from my Pixel 2 XL using Tapatalk |
|
| |
|
09-30-2019, 11:07 AM
| #3 |
| I wanna be Dave Join Date: Oct 2010 Location: Caldwell ID.
Posts: 4,328
| Re: Any info out there about rewinding mass produced 540 motors?
Why bother? 35t HH 540 Trailmaster is $14 A non sealed can, can be taken apart.... Windings removed, I guess.... |
|
| |
|
Any info out there about rewinding mass produced 540 motors? - Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Info on Crawlmaster 540 | Oldskoolcj | Electronics | 0 | 05-22-2012 11:55 AM |
| Stock motors rewinding. [Update] | Big Pitt | Redcat Crawlers | 7 | 08-14-2011 10:06 AM |
| rewinding motors | azrcr | Newbie General | 1 | 06-06-2010 09:20 AM |
| Mass produced vs. handwound motors... | Pappy | Electronics | 7 | 12-07-2009 04:12 PM |
| rewinding motors | Madcratebuilder | Newbie General | 4 | 01-30-2006 02:26 PM |
| Thread Tools | |
| Display Modes | |
| |
Linear Mode
