FlySky fs it4S setting for 4ws/crab

[ToxicFire]

Hello guys so ive been doing searches and reading on 4ws and crab crawling and currently i have a scx10 made into a 6x6 and i have rear steering and crab with a spektrum radio no issues everything works as i want however as you see my title i have a flysky fs it4s radio thats just sitting and want to use it on this crawler.

Question is how is this setup and say channel 3 will have the rear servo how to i set it up and have it working with a switch for example switch 3 on the radio i push down it puts in rear steer then push down again and now its 4ws and you get the point haha.

Sorry for the long message just trying to get everything in here.

If someone can give me steps on doing this that be great.

[Druxus]

I'm at work so I don't have the radio sitting in front of me. You can set switches up to either toggle between the modes or set the switch to a mode do you want to run. On the vehicle I have rear steer on I have one switch for front steer, one for rear steer, and one to cycle between the modes.

[ToxicFire]

Originally Posted by Druxus

I'm at work so I don't have the radio sitting in front of me. You can set switches up to either toggle between the modes or set the switch to a mode do you want to run. On the vehicle I have rear steer on I have one switch for front steer, one for rear steer, and one to cycle between the modes.

When you have time if you can post how you got this to work that would be great.
I want one switch to cycles each mode.