06-11-2020, 11:19 PM | #1 |
Quarry Creeper Join Date: May 2020 Location: Canada
Posts: 219
| Hw 1080 calibrating
I cant get the 1080 to calibrate properly. I do the neutral one and hit set, it beeps. Then i go full forward and hit set and no beep. But if i do reverse it beeps. Then i have to do forward last. No matter how i try it, i still have to do reverse first. Swapped motor wires, Reversed the channel, still have to do reverse first. Any ideas whats going on?
|
Sponsored Links | |
06-11-2020, 11:41 PM | #2 |
RCC Addict Join Date: Jun 2017 Location: Canada
Posts: 1,742
| Re: Hw 1080 calibrating
Press Cal between each step. Google : hobbywing 1080 calibration Sent from my Pixel 2 XL using Tapatalk |
06-12-2020, 12:58 AM | #3 |
RCC Addict Join Date: Jun 2008 Location: Mudville
Posts: 1,592
| Re: Hw 1080 calibrating
Sounds like you need to reverse the throttle setting on the TX. when you pull it, the rx/ is telling the esc to reverse, when it is looking for a forward setting. So reverse the throttle direction on the servo, then program the ESC. Once that is done, check the rc direction, if it goes backwards when you pull the trigger, you will probably have to swap a couple of the motor wires around. Or just program the esc using rvs first, then once programmed, change the throttle direction. then check if you have to swap motor wires around. Thats what I think you are experiencing. |
Hw 1080 calibrating - Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Русские идут (the Russian is coming) - our ironworker goes Scale... | nicodrive01 | Scale Videos! | 8 | 05-07-2011 10:33 PM |
| |