|
| LinkBack | Thread Tools | Display Modes |
12-07-2022, 12:52 PM | #1 |
Newbie Join Date: Nov 2022 Location: Europe
Posts: 8
| Winch controller connections troubleshooting
I've got the following (picture). It turns one way when I press button A, but doesn't turn the other way. Servo is 360 with wires direct to motor. Hooking the multimeter, I get a constant 5,55V out the red JST connector (that goes to the motor). Pressing button A i get 8,18 (so the LiPo). Pressing button B i get something like -227mV I would assume presing B would give me reverse voltage from the LiPo so the motor would reverse. Is there a way I can remedy this? |
Sponsored Links | |
12-07-2022, 03:09 PM | #2 |
I wanna be Dave Join Date: Jul 2005 Location: North Idaho
Posts: 3,648
| Re: Winch controller connections troubleshooting
Pictures would be helpful here.... It all depends on what your are trying to control your winch with. "A" and "B" buttons really don't say how it is wired, or what is actually controlling it. |
12-07-2022, 04:33 PM | #3 | |
Newbie Join Date: Nov 2022 Location: Europe
Posts: 8
| Re: Winch controller connections troubleshooting Quote:
It's a unit from AliExpress with a two button controller. | |
12-07-2022, 04:50 PM | #4 |
I wanna be Dave Join Date: Jul 2005 Location: North Idaho
Posts: 3,648
| Re: Winch controller connections troubleshooting |
12-07-2022, 05:44 PM | #5 |
Newbie Join Date: Nov 2022 Location: Europe
Posts: 8
| Re: Winch controller connections troubleshooting
Ok, let's see if this works...link to picture https://photos.google.com/photo/AF1Q...fyEnZd80L4YVuG And link to product https://www.aliexpress.com/item/4000...yAdapt=glo2pol |
12-10-2022, 10:07 AM | #6 |
I wanna be Dave Join Date: Jul 2005 Location: North Idaho
Posts: 3,648
| Re: Winch controller connections troubleshooting
Sorry for taking so long to get back to you. What kind of connector is on the output of the control box, and is it 2-wire or 3-wire? If it is a red JST, then the control box should be sending +5VDC (ish) when one botton is pressed, and -5VDC when the other botton is pressed. If there is a servo connect on there (3-wire), then it might be sending a high voltage along with servo commands intended for a 360-degree servo. I am guessing that the control box is only 2-wire, and something has fried inside. Recommend taking a look at Hey-OK's electronics offerings for stuff like this. You'll pay a little more, but all of his stuff works great and is very reliable. HeyOK's RC Electronics items (all in one place) |
12-14-2022, 01:34 PM | #7 |
Newbie Join Date: Nov 2022 Location: Europe
Posts: 8
| Re: Winch controller connections troubleshooting
Aw man, I was afraid something might have fried, because it's definitely not +5/-5 :( Will take a look... |
Winch controller connections troubleshooting - Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
DX3R + servo winch troubleshooting | Chappy4o | Electronics | 7 | 02-09-2011 11:05 AM |
| |