RCCrawler Forums - Servo mount for Berg V3

RCCrawler Forums (http://www.rccrawler.com/forum/)

- EnRoute Berg (http://www.rccrawler.com/forum/enroute-berg/)

- - Servo mount for Berg V3 (http://www.rccrawler.com/forum/enroute-berg/475562-servo-mount-berg-v3.html)

Quiel

12-28-2013 02:01 PM

Servo mount for Berg V3

I am using a Hitec 7980 servo and the servo mount that came with the kit does not fit my 7980 servo. Its too narrow and the screw holes does not match.

Any suggestions on after market parts.

stubs179

12-29-2013 07:30 AM

Re: Servo mount for Berg V3

I don't know of any aftermarket support for v3 axles. You will most likely have to make something yourself? If you want bolt-on you will want to go to a v1 axle.

I don't know if the servo will fit between the motor but if it does Erik at Dluxfab.com sells a universal servo mount that you could mount to your axle tube to hold the 7980 servo.

All times are GMT -6. The time now is 05:09 AM.