bulldog berg D-lux rcbros NewEgo2
 

Hello everyone =)
this is my new berg v1 ...........

front axles :

case delrin carbon -classicutcustom
tube delrin - D-lux
gears -RcBros
axle shafts- wraith axial
c-hub xr10 - vanquish
knukles wraith - vanquish
support electronic - D-lux
screw blue -fastener express

rear axles :

case delrin carbon - classicutcustom
tube delrin - D-lux
gears -Rcbros
axle shaft aluminium -D-lux
screw blue - fastener express

link titanium -
chaotic crawlers 0.5 lower berg
crawler keller 0.4 upper berg

shocks -losi mini T rear
shocks -losi K.factory
shock absorbers - axial icon aluminium

whell carbon -YTC

tires : voodoo

electronic :
SideWinder micro: castel creation
ccbec : castel creation
servo : futaba bls 172 hv
future engine : puller 400 40T

chassis : ???
suggestions are welcome :mrgreen::mrgreen::mrgreen::mrgreen::mrgreen::mrgr een::mrgreen::mrgreen:

Re: bulldog berg D-lux rcbros NewEgo2
 

reptile ..........+1000000

Re: bulldog berg D-lux rcbros NewEgo2
 

D-lux ultra ?
pitbull 2.2 pro ?
secret agent ?
duble agent ?
reptile ?

Re: bulldog berg D-lux rcbros NewEgo2
 

I have ran a few different moa chassis and my DLux ultra is by far my favorite I just pulled off my best finish at our last comp which was my first comp with my dlux chassis . And Erik has the best customer service that I have dealt with .

Re: bulldog berg D-lux rcbros NewEgo2
 

Pit bull all the way!!!

Re: bulldog berg D-lux rcbros NewEgo2
 

But those are all bodiless rigs, and we all know the National Champ runs a bodied rig.

And there very few bodied chassis available. I did however just finish a small batch of the Mark II.

http://i21.photobucket.com/albums/b2...ps08631959.jpg

Good luck on your ventures"thumbsup"

thanks for the advice, in fact the d-lux ultra talked about it just the other day me and a friend 'cause it seems to be very effective even on rocks with many steps (due to the curve of the link)

but 'I have also seen that the pitbull is widely used

instead the chassis without cab from our parts is used with AX10 instead of moa
therefore remains in doubt ........ we say that the weight but 'is favored because' very light

at this point, as has been made of the new chassis and apparently from videos also appear to be valid, what advice would you give me??
other question? how much should weigh a crawler to go well??

question? to make a regular race, which features should have a crawler??
measure tires?
Minimum and maximum height from the ground?

Re: bulldog berg D-lux rcbros NewEgo2
 

In recent years I've only used crawlerkeller frames (before the fly and then the reptile v1) finding myself very well ... in europe are readily available, fair price and with dedicated links (lucky for me that are denied in achieving link ...). are also all available spare parts.

Re: bulldog berg D-lux rcbros NewEgo2
 

in ok, so only the frame keller ...... but do you think goes well or badly??

Re: bulldog berg D-lux rcbros NewEgo2
 

I'm not saying there is only one, just for us Europeans is the 'easier alternative ... no customs, no shipping costs low and short waiting times ...

Re: bulldog berg D-lux rcbros NewEgo2
 

ok got it, so in the end the only way to avoid extra expenses is to buy in europe! in fact it is true, but 'there is little

true ... although I really like the D-Lux and I'm sure that will do the trick, but between shipping (too expensive since it takes over a month to arrive) and customs (over 23%) ...

a friend of mine was able to find such a specialist and maybe convince him to give it to me ... if I can keep you updated .... anyway being discontinued is a rare commodity, perhaps (since you already have the wheels) may look YTC ...

If you know to tell me something of the frame Smash Chaotic?? seems like a nice chassis and
perhaps it is still around

it is also nice d-lux, but 'you must attach your links! do not go there maybe other

http://i1286.photobucket.com/albums/...ps1c655137.jpg
and so you're able to find it, well, well ...... but tell me, I found this model, how do you like the chassis??
however, very lucky, maybe you put the photos =)

I know someone who knows where to find the chassis of the photo, this seems valid as an alternative

I know the chassis, the Italian champion speaks very well (although it uses a chaotic switches ...)

I dream at night ... I hope to get the reptile to me great satisfaction but I always like to change (when possible)

maybe it will be 'his next chassis, for now does not want to disclose the information and thus will not lean too (this is what I think)

http://i1286.photobucket.com/albums/...pscb3312b7.jpg
I found this on ebay smash , I would say it is very nice, I also very light

it is right to change, but 'we must do better! I've seen a few videos of reptile (sumo youtube) and it seems to me that runs very well
http://youtu.be/bJiwlTVp0Uk

Re: bulldog berg D-lux rcbros NewEgo2
 

works very well but is in configuration 60/40 and would like to try something more balanced like the 50/50 to see if I can take a bit of weight to the 'front.

Re: bulldog berg D-lux rcbros NewEgo2
 

understood! so please excuse my ignorance, but only if you change the chassis, and the distance that is 60/40 should remain unchanged?

Re: bulldog berg D-lux rcbros NewEgo2
 

some frames work better with certain configurations that are usually given by the length of the link ...

Re: bulldog berg D-lux rcbros NewEgo2
 

of course, but 'only if you change the frame, in my opinion solve a 55/45 at best!
You should also change the links to have the effect of 50/50