http://www.rccrawler.com/forum/ en Thu, 09 Sep 2010 21:48:48 GMT vBulletin 60 http://www.rccrawler.com/forum/images/misc/rss.jpg http://www.rccrawler.com/forum/ http://www.rccrawler.com/forum/showthread.php?t=268650&goto=newpost Tue, 07 Sep 2010 07:36:46 GMT Perhaps the weakest point on an AX10 axle is where the C meets the housing. This steel insert gives the axle housing strength and weight right where it needs it. These toobs are chamfered on one end for bearing relief near the C. 42 sets left EDIT: It is important to note, these will... Perhaps the weakest point on an AX10 axle is where the C meets the housing. This steel insert gives the axle housing strength and weight right where it needs it.

These toobs are chamfered on one end for bearing relief near the C.

42 sets left

EDIT: It is important to note, these will not work with the stock dog bones.

For a detailed write up on how to do the install, check here.

http://www.rccrawler.com/forum/showthread.php?t=266929





NOTE: THESE ARE NOW GOING TO BE OFFERED DRILLED AND TAPPED!

EDIT: the cost is going to be $28 per pair shipped. This has gone up due to the drill and tap. For US domestic market, these will be shipped out of San Mateo, CA.

You can paypal me at casey.pierpoint@gmail.com

Casey ]]> Axles, Trannys, T-case KC_JoNeS http://www.rccrawler.com/forum/showthread.php?t=268650 http://www.rccrawler.com/forum/showthread.php?t=268554&goto=newpost Mon, 06 Sep 2010 22:30:37 GMT Ok guys,,,here ya go.

Paradox Pin Lox,,,CVD pin keepers

Set of 6 shipped is $10.00 in the U.S. Pm me for international orders. The really nice thing about these is,,,you dont need to mess with those little set screws anymore. The PPL's will keep your pins in and the extra binding force of the set screws is eliminated.

Paypal to rmdesignworks@yahoo.com

First shipping for these will be Friday Sept. 10th. Get your orders in now.




]]> Axles, Trannys, T-case rmdesignworks http://www.rccrawler.com/forum/showthread.php?t=268554