Who had the......

[fla_cracker]

Who had the eye glass case winch controller? Was it sneakymax?

Or can someone point me to a thread or how to on the subject. Internet and eccentric searches have not been productive ...

Thanks

[sneakymaxx]

lol yup was me...what ya need?

[fla_cracker]

What's in the box, and how your servo is rigged.

I rigged a servo for winch duty, but have no idea how I'm gonna control it...lol

[sneakymaxx]

i have an actual winch im running....the box is an old detachable radio face box, small lipo, and a 3 position momentary switch from ace. the switch has 6 spades on bottom. deans with some wire with spade connectors to the middle 2, and then take 2 short lengths of wire and strip all ends. take one end of that and a length of wire with your winch/servo connector on the other end.....i used about 4 feet of total length and cut what i needed from that for connections.....the other end of the short wires, plug into one end of the switch, and then you have to cross over and connect the other end of the short wire with the long section to the other end of the switch....and it should be crossed when you do that.....positive to the negative side and negative to the positive....thats what gives you back and forth thru one wire, along with the switch.

[sneakymaxx]

hope that helps
if not, use bing.com and look for HOW TO WIRE A WINCH SWITCH

[panama]

Originally Posted by sneakymaxx

i have an actual winch im running....the box is an old detachable radio face box, small lipo, and a 3 position momentary switch from ace. the switch has 6 spades on bottom. deans with some wire with spade connectors to the middle 2, and then take 2 short lengths of wire and strip all ends. take one end of that and a length of wire with your winch/servo connector on the other end.....i used about 4 feet of total length and cut what i needed from that for connections.....the other end of the short wires, plug into one end of the switch, and then you have to cross over and connect the other end of the short wire with the long section to the other end of the switch....and it should be crossed when you do that.....positive to the negative side and negative to the positive....thats what gives you back and forth thru one wire, along with the switch.

Im going to HaVe tOo lOok this one up

[stelerzman]

Look into Heyok, he makes several servo winch controllers for 2 & 3 position RX's.

Here's a link. HeyOK's RC Electronics items (all in one place)

[fla_cracker]

Holy resurrection Batman.....!!!!!

But seriously, thanks for the reply. Hopefully this will help others just coming in.

[stelerzman]

The Heyok controller is " PNP", Plug n Pull.