Scaling my bouncer buggy

[yoda@4x4]

Originally Posted by Exocaged

so an rx can take 7.4V? I have read that 6V is the highest you want to run. This winch would be on its own BEC, not the one feeding the rx and servos. So one BEC would be at 7.4V for the winch and a then a different BEC would be set at 6V for the rx and servos. I want to wire it kinda like you do with HV servos.

Will this work?

Like this except instead of it being a servo, it will be a winch



Or do you think just one CCBEC set at 6V would be enough to handle 2 servos and power a winch at the same time?
.

yes that will work I have run a few thing that way before...

Originally Posted by Exocaged

I'm trying to get the hpi interior in this thing and I just don't know if it will fit. Its close though. Gotta try the helmet part this evening to see if it will make it. I have recently upgraded a few driveline parts on it. ST chubs and knuckles all around, Blitz axles off ebay which seem to be pretty descent. I also put on a set of SAVOX 1231sg 444oz/in servos in it. This thing will make a U-turn almost within its own width!!!

Ya when I built my F-Toy I had to modify my HPI setup to make it work

[jeepgeek2002]

Any updates on the interior mod?

[Exocaged]

Kinda sorta. I gotta work on the mounts for them. Should have that part done and hopefully paint them soon.

[Exocaged]

Not to change subjects here but would this body work to scale my venom creeper?

Traxxas Revo Body w/Decal Sheet (Clear) [TRA5311] | RC Cars & Trucks - A Main Hobbies