![]() | #1 |
Try to Bend it ![]() Join Date: Aug 2009 Location: Perth Australia
Posts: 3,163
| ![]()
Will a full size cobalt puller fit into an R1?
|
![]() | ![]() |
Sponsored Links | |
![]() | #2 |
Pebble Pounder Join Date: Oct 2009 Location: South Korea
Posts: 131
| ![]()
It doesn't look like it, but I haven't actually gotten the truck yet so can't say for sure.
|
![]() | ![]() |
![]() | #3 |
Try to Bend it ![]() Join Date: Aug 2009 Location: Perth Australia
Posts: 3,163
| ![]()
HMM, might have to settle for a 500 puller.
|
![]() | ![]() |
![]() | #4 |
I wanna be Dave Join Date: Oct 2007 Location: Castle Rock, WA
Posts: 8,533
| ![]()
A Integy type 540 motor with the cheap end bell just fits. If you bump up to a better 540 with a larger endbell/head sinks it will not fit. You have to move the trans back on the second set of holds in the skid. I run the ripper7777777 so this option is out. I wanna say anything over like 54mm is too long for stock configuration. |
![]() | ![]() |
![]() |
Thread Tools | |
Display Modes | |
| |