List of compatible parts between the BOm and the SCX 10 II
 

Hi
Does anyone have a full list of the interchangeable or compatible parts between the BOM and the SCX 10 II?


thanks

Re: List of compatible parts between the BOm and the SCX 10 II
 

Yes! Please!

Re: List of compatible parts between the BOm and the SCX 10 II
 

I certainly don't have a full list, but here's what I have used from a 10.2 on my son's gso2:

Knuckles: direct fit, no mod needed.

Front shock hoops/panhard mount: Direct bolt on, but the panhard length needed a slight length adjustment and the servo had to be shimmed up a tiny bit for the servo horn to clear.

Servo mount: direct fit.

If others could keep adding to that list, I'm sure you'll have a complete list compiled in no time. If you peruse bilinvic's and soze's threads, they have more interchangeable parts listed there.

Re: List of compatible parts between the BOm and the SCX 10 II
 

I wonder if any of the skid guard plates and axle protectors would fit.

I am using one of those ebay aluminium front bumper mounts to strength up the chassis. The two holes are 1.5mm closer than the stock plastic one, but I could still easily slide my GS02 Double Cab's bumper in.

Re: List of compatible parts between the BOm and the SCX 10 II
 

I guess the list from SSD is a start.

PARTS FOR GMade BOM GS02Parts for Gmade BOM GS02

Re: List of compatible parts between the BOm and the SCX 10 II
 

Here's my notes on the subject.

C-Hubs don't fit without significant work. It's been a while since I built my Bom but from what I remember the issue was that the thru-pin that holds the knuckle on and prevents rotation is at a different spot and 10.2 than it is on a Bom.

Knuckles 98% fit but you need a thin (0.2mm?) shim on the top and bottom for a proper fit in a Gmade C-Hub. Realistically you can get away without the shim and you'll probably never know the difference.

Servo mount fits perfectly with no mods. Except for the holes that mount the "oilpan", those will need to be redrilled on the oilpan.

Shock hoops can be made to fit but you need to lengthen the panhard, shim the servo up and use a bent (offset) rod end.

Basically, I only recommend the servo mount. Everything else (shock hoops, c-hubs, knuckles etc...) is made for specifically the Bom so I don't see cross-over fits as being important.