| |
01-09-2019, 06:59 PM
| #1 |
| Newbie Join Date: Oct 2018 Location: Vail
Posts: 13
|  Drive shaft woes
So I'm running the rigs with my daughter yesterday, naturally I give her the sawback since its slow, she is 5 so speed isn't necessary for her, she high centered on a rock and popped the e-clip off one of the pins which of course was instantly lost, any idea as to what pin I can use in the mean time until I can order a new one? The only hobby store in Tucson is closing its doors and will not order it for me. Was going to try to rig up a drive shaft from a traxxas if possible, ace hardware by me has hobby cars, but only carry traxxas. Any help will be much appreciated. Bjorn |
|  |
| Sponsored Links | |
| | |
|
01-09-2019, 06:59 PM
| #2 |
| Moderator   Join Date: Sep 2008 Location: PA
Posts: 13,935
| Re: Drive shaft woes
A lot of people use cut down drill bits in a pinch.
|
|
| |
|
01-09-2019, 07:49 PM
| #3 |
| Newbie Join Date: Oct 2018 Location: Vail
Posts: 13
| Re: Drive shaft woes
Alright, makes sense, I was thinking about cutting an Allen key and turning it with a drill to cut some grooves to accept some e-clips, but that sounds easier
|
|
| |
 |
Drive shaft woes - Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| best way to join a rwvo drive shaft to the output shaft on the axle | TRAV | Kyosho Crawlers | 12 | 01-29-2012 07:37 PM |
| Drive Shaft | olskool4o7 | Losi Mini-Rock Crawler | 2 | 06-26-2011 12:37 AM |
| drive shaft help! | counter6862 | Newbie General | 3 | 04-27-2010 05:46 AM |
| ***MIP C-Drive Drive shaft for the AX10...GIVEAWAY*** | Rockpiledriver | RCP Crawlers | 153 | 07-01-2008 11:18 AM |
| |
Linear Mode
