|
| LinkBack | Thread Tools | Display Modes |
08-20-2008, 12:42 AM | #1 |
Newbie Join Date: Aug 2008 Location: uk
Posts: 2
| Newbie..Nylint 1:6 front axle spares needed Hi, i dont know if you can help but I am desperately trying to get hold of a left hand side outer drive shaft for a 1/6th scale nylint crawler. The is the piece that the bearing race goes onto and has the slotted hole for the inner shaft to go into and the outer end has a rounded end with a roll pin through it to transfer drive to the wheel. I have tried everywhere to get one, funshine who shipped them into the uk cant help and I keep checking ebay but to no avail. Can anyone out there help or have you any ideas where i could get one as my crawler is busted at the moment. Kind regards Greg ps......great site by the way-loads of really good ideas and crawlers!! |
Sponsored Links | |
08-26-2008, 02:14 PM | #2 |
Newbie Join Date: Aug 2008 Location: uk
Posts: 2
| Bits still needed
Hiya, If anyone has a good front axle for a nylint 1:6 scale, or CV joint as described in the posting above, please help me out. I will buy through ebay, no messing, and pay for shipping to the UK. Please help me out guys, thanks Gregster |
08-26-2008, 02:34 PM | #3 |
Pebble Pounder Join Date: Apr 2006 Location: Newton
Posts: 137
|
I just seen one on Ebay last week for 45.00 I searched Nylint crawler.
|
08-26-2008, 04:31 PM | #4 |
RCC Addict Join Date: Feb 2008 Location: Hiatus..sutiaH
Posts: 1,620
|
Unless you are hardup to run a Nylint I would recommend to spend your money elsewhere. If you are not hardup I would get another chassis/kit to crawl with. Nylints can be fun after hours and tons of $ into them. The sure do look good falling down stairs though. |
| |