Zero 3.5 with Bully axles? Anyone running them?
 

Looking for the perfect chassis to complement the bully axles that just arrived. Any thoughts? I am looking at DNA and the Zero of course. So far I think the Zero is for me. Does anyone have an input?

thanks fellas

Everything designed for the bergs as far as the zero chassis and package will work with the bully's.

Good to know, and thanks for the reply. Sure do like those Delrin bent links!

Well everything but the tie rod.

i used the tie rod on the hr moa"s and i only had to cut 1/4 inch off the long side. almost 0 akerman and only 40%on my epa's

Thats good to know. Some people are afraid to mod anything though.....

I figured the stock tie rod would not fit. I will only buy the links and the chassis. I have a tie rod that I made that works pretty good. Again, thanks for the great info!

I built my Bullys on a KK4.0 to start. Im currently experimenting with a stick type chassis but the KK steering link is great on my bullys once cut down about an inch. I liked the KK on my bullys but the downside is with the bullys so narrow at the shock/lower link mounts its tough to get it just right on a chassis as narrow as the KK when its stock I put a wider skid in it and it was great. Stock axial skid bolts right in to the holes in the KK plates and its just wide enough. My next chassis experiment will be the Zero-T on the bullys whenever i get around to ordering it. "thumbsup"

The notch in the KK steering link made a great servo guard on my setup.
http://farm4.static.flickr.com/3226/...e81ea85d8b.jpg

I mounted the KK delrin bent links on my Zero 3.5 chassis running HR MOA axles and it shortened my rig up quite a bit. Read ALOT.

Is that normal?

I'm running a TAG chassis with my Bully axles "thumbsup" it is Alumi and weighs 2oz;-)

I use some of Special K's products in my Bully build. Check out my thread here: http://www.rccrawler.com/forum/general-crawlers/148315-gemini-doubled-bully.html "thumbsup"