MIP & Traxxas compatibility. Has anyone tried Summit axle shafts. http://www3.towerhobbies.com/cgi-bin...?&I=LXWWF7&P=Z with MIP C-Drive Hub for the Axial AX-10? http://www3.towerhobbies.com/cgi-bin...&I=LXWLE3&P=SM I am eventualy going to use my Axial trans in a Maxx based super and would like to use this set up as drive shaft. It would allow the use of the 5 mm output from the trans and the 6 mm pinion shaft on the Maxx diffs if it would work. |
Try Yotachump. 6mm outputs for axial tranny for maxx shafts http://www.rccrawler.com/forum/showt...ight=yotachump |
^ I don't think Yota makes them any more. |
I have not seen the CDW 6mm outputs offered anytime recently. |
Well then never mind. I Tried |
All times are GMT -6. The time now is 07:48 PM. |
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Content Relevant URLs by vBSEO ©2011, Crawlability, Inc.
Copyright 2004-2014 RCCrawler.com