06-09-2009, 12:25 AM | #1 |
Quarry Creeper Join Date: Feb 2008 Location: New Rochelle
Posts: 363
| GC2 cobalt 7t
Any one put a cobalt motor in the gc2? will it fit?
|
Sponsored Links | |
06-09-2009, 08:16 AM | #2 |
I wanna be Dave Join Date: Jun 2005 Location: drillin Holes for the man
Posts: 2,736
|
I might be wrong but if memory serves me right it won't fit.
|
06-09-2009, 09:01 AM | #3 |
Quarry Creeper Join Date: Feb 2008 Location: New Rochelle
Posts: 363
|
Thanks. on the holmes hobby web site its says its 2.5 inches long. Is that the motor or the shaft? What a measurement so i can figure it out?
|
06-09-2009, 09:12 AM | #4 |
Rock Crawler Join Date: Sep 2008 Location: N.E. Mpls
Posts: 854
|
2.5 endbell to endbell
|
06-09-2009, 09:16 AM | #5 |
I wanna be Dave Join Date: Jun 2005 Location: drillin Holes for the man
Posts: 2,736
|
That is the motor length not including the shaft. |
06-09-2009, 09:57 AM | #6 |
Quarry Creeper Join Date: Feb 2008 Location: New Rochelle
Posts: 363
|
Anyone have a gc2 and know if it will fit or not? I think it will be really close
|
06-09-2009, 05:56 PM | #7 |
RCC Addict Join Date: Nov 2006 Location: southaven
Posts: 1,934
|
it will with some very careful grinding on the chassis and back end bell. take your time i think it took me about an hour to do grind check grind check. dont make it to thin at the bottom this is the only pic i have of it |
06-15-2009, 06:02 PM | #8 |
Tire&Foam Extraordinaire Join Date: Jun 2007 Location: C.I. Compound, Tyler, Texas
Posts: 5,601
|
It will fit, but like jeepcj578 said, take your time and only remove the smallest amount. By the way, that was a 7T puller and it would get much too hot on 3S so I sold the motor. Great power, wheel speed and low speed resolution though for the short time it was in there. |
Thread Tools | |
Display Modes | |
| |