servo pics doe"s anyone have any pics of the nylint circuit board that has a standard servo installed so i can see how it is all wired up? any help would be greatly appreciated thanks,ron |
no pic, but this should explain it. i used stock wiring & cut it off of the steering motor. http://www.rccrawler.com/forum/general-crawlers/16025-serv-stock-radio.html |
you dont have a pic of the actual wiring do you? if not is there a chance you take one real quick? |
anyone |
After reading the thread that jeepguy linked I think that if you can't understand what's going on it's a good chance that you'd be in over your head with this mod. |
2 wires from truck/2 wires from servo "motor" hook them together. not the 3 wire tail of servo, but the servo motor itself. i have put 56 hours in this week since sunday & its only thursday. plust i had alot of hours last week without a day off. & i gotta get up at 5 tommorow & put in about14 or 15 hours, & a bunch of hours on sunday. so monday when i have time & my brain is functioning again(if i dont get called in to work on manday) i will get some could pics of my servo wiring. i am building a new truck with the low gear mod, & my tired brain just relized that i have another front axle now so i am gonna do 4 wheel steering also. so i will get some good pics & a better step by step write up of it all. & maybe some axle shavin pics too. gotta go feed my brain beer now, :| |
thanks that'd be great |
All times are GMT -6. The time now is 04:08 AM. |
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Content Relevant URLs by vBSEO ©2011, Crawlability, Inc.
Copyright 2004-2014 RCCrawler.com