01-21-2006, 08:44 AM | #1 |
Quarry Creeper Join Date: Jan 2006 Location: Reno
Posts: 448
| no front power
I recently bought a 1:18 nylint jeep, and after the first day of using it hard the front tires don't grab. when i pick the jeep up, they spin, but when they come in contact with an obstical they just stop. any ideas whats wronge?
|
Sponsored Links | |
01-21-2006, 09:53 AM | #2 |
06 Super National Champ Join Date: Jun 2004 Location: Stark Industries Bar and Grill
Posts: 11,361
|
Moved out of Tool and Procedures into 1:18 forum where it belongs.
|
01-21-2006, 04:15 PM | #3 |
Quarry Creeper Join Date: Aug 2005 Location: crescent city
Posts: 304
| make sure your switch is in low or high(same as rear axle) could be the motor support in axle broke off causing the motor to push over & slip gears(fix with electrical tape if so) |
01-21-2006, 04:46 PM | #4 |
Quarry Creeper Join Date: Jan 2006 Location: Reno
Posts: 448
|
i figured it out, after tearing the whole high/low assembly apart i saw the metal gear for the low had stripped the plastic part, just bent the tabs and filled in the grooves with rubber cement and made every thing a little tighter and it runs well.
|
Thread Tools | |
Display Modes | |
| |