tranny extension? has anyone ever made one? ive got a t-case under the floor, that i need a extension on so i dont have to hack the floor . has a vendor ever made one, or anyone ever made a one off? basically i need a straight shaft the slides over the t-case input shaft thats extends it forward 1.5" that i can then put the driveshaft on the end of. |
I had a couple made for the HPI GRU basically same idea but I also increased the size of the shaft with it.. was no where near that length. couldn't you just use a drive shaft laid flat and then a maxx knuckle as a carrier bearing, then attach the other drive shaft to that? or is the clearance to tight for that? I think with a 1.5 extension you will be adding allot of load to the bearings in the tcase.. |
i've had this idea in my head a while, what about a "drill bit extension" I don't know what diameters they come in, but you could cut it to whatever length you need, and I dont imagine them being to expensive, and I bet all hardware stores have them http://www.hardwarestore.com/media/p...5_front200.jpg |
Quote:
yeah there barely room for the shaft under the floor. fred. thats pretty intresting, and sort of exactly what i need. never hear of those. |
this might work all id need is another 5mm shaft. http://cdn5.hobby-lobby.com/images_p.../546_large.jpg http://www.hobby-lobby.com/5mm_5mm_s...r_546_prd1.htm but sold out :( |
|
possibly. looks like its about a 3/8" extention. |
Got any TLT dogbones and cups? |
1/4" should slide right over the 5mm shaft this is a hex set up but I dont really think it would throw anything off. I think fred has got the right idea.. worst case you drill out the hex and stick a brass bushing in there to take up the slop.. http://www.mcmaster.com/#wood-boring-drill-bits/=ae8vz8 Part Number: 3127A77 |
Stang Killa I made this for my Honcho and it has held up to a 23 turn on a 3cell just fine. Shoot me a PM with some dimensions of what you want and I'll build you a couple,these are EZ for me. http://i44.photobucket.com/albums/f4...3-31-10006.jpg http://i44.photobucket.com/albums/f4...3-31-10007.jpg I made this one out of 303 Stainless but we have other material at the shop . |
Quote:
like three real short ones ane one to get the maxx shaft to clear my spur without modding pm me |
Here ya go Stangkilla....... http://i44.photobucket.com/albums/f4...v/DSCN5572.jpg http://i44.photobucket.com/albums/f4...v/DSCN5569.jpg |
Those look really nice. |
All times are GMT -6. The time now is 01:37 PM. |
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Content Relevant URLs by vBSEO ©2011, Crawlability, Inc.
Copyright 2004-2014 RCCrawler.com