How do i mount this? Tough Armor Competition Stinger Bumper Axial SCX10 How do i mount this? Tough Armor Competition Stinger Bumper to fit Axial SCX10 |
Re: How do i mount this? Tough Armor Competition Stinger Bumper Axial SCX10 In these pics it looks like some button head screws will work for you: http://www.beadlok.com/product/image...1/4WD_3738.jpg http://rockycountry.com/product/Tube/DSC_0098.jpg |
Re: How do i mount this? Tough Armor Competition Stinger Bumper Axial SCX10 CA glue as far as I can tell. I would try medium viscosity. |
I believe it should mount onto your current bumper brace screw holes. You will probably want some screws and lock nuts though. |
Re: How do i mount this? Tough Armor Competition Stinger Bumper Axial SCX10 Quote:
|
Quote:
|
Re: How do i mount this? Tough Armor Competition Stinger Bumper Axial SCX10 That was clearly a joke. You can see plain as day there are two bolts on each side of the bumper connecting to the frame. You may have to drill a new hole on each side along with using the existing holes. |
Re: How do i mount this? Tough Armor Competition Stinger Bumper Axial SCX10 There are holes in the chassis where the screws go through into the brace for the battery holder and there is a other hole where another brace is. |
Re: How do i mount this? Tough Armor Competition Stinger Bumper Axial SCX10 them screws are from the front brace take out the screws from the brace then slip the bumper over the rails an match the holes up with the brace then put the screws in an ur done |
Re: How do i mount this? Tough Armor Competition Stinger Bumper Axial SCX10 I noticed this is a somewhat "older" thread, but I'm curious to see how the bumper install came out... I purchased the same bumper for my JK, along with an RC4WD Warn Winch and had to return the bumper because it would not fit the winch. Did anyone else experience this, because I absolutely loved the look of the bumper! Additionally, does anybody know if the fairlead design was changed on the Winch, maybe the new one is bigger...because that was the issue, it wouldn't go through the opening in the bumper. Ultimately I ended up ordering a JK Recover Bumper, but haven't installed it yet... was hoping to get a JK Bumper w/Grill Guard. http://www.rpphobby.com/v/vspfiles/p...4Z-S1193-7.jpg http://www.rpphobby.com/v/vspfiles/p...4Z-S1010-3.jpg |
I think they make an adapter plate to run that new bigger winch in the old bumpers, but I can't be sure. They also make a bunch of new bumpers that allow that winch to fit |
All times are GMT -6. The time now is 01:29 PM. |
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Content Relevant URLs by vBSEO ©2011, Crawlability, Inc.
Copyright 2004-2014 RCCrawler.com