Scx10.2 servo mount

[Blandguy]

I was scanning through parts at work on a lunch break and spotted somewhere a servo mount that moved the mounting position toward the front of the truck to keep from hitting the panhard mount. If anyone knows of a good solution to the ole servo horn hitting the panhard mount and my servo horn is actually hitting the frame too. May just need to file a bit of the metal off the sides of my servo horn

[Blandguy]

Originally Posted by hobbyjumper

Big can of worms, but I firmly believe any mod that messes majorly with legendary Axial geometry is a bad mod. After hours and hours of experiments, the most sensible solution is simply a longer servo horn with the drag link in the outermost hole. This will give you all the turning radius you desire but without a servo horn arc big enough to cause parts to come in contact. You MUST set your servo endpoints so pushing stops short of the 45-degree max, or you will burn out your servo motor.

My own SCX10ii is set up this way, and it's tough, reliable, headache-free.

Cheers...

ps: This assumes you have installed a servo with enough torque for crawling, in the first place.

No doubt. My endpoints are set. And it's not a stock servo for sure. Filing down the servo horn isn't going to change the geometry at all. I'm just trying to get closer to the same amount of steering in either direction. I've tried re-clocking the servo horn. I think it's just going to require more tinkering