hustler+r2d ok i got a hustler and i orderd a r2d tranny, but the mount that hooks on to the tranny the the servo mount hooks to is just over 1/8 inch too wide to fit inside the chassis if this is normal, how are people getting the mount into the chassis thanks bigdog |
You have to grind some material off each side of the bracket to get it to fit. Grind a little and test fit, grind a little and test fit. It will work. http://www.rccrawler.com/forum/axial-ax-10-scorpion/90184-axial-ax-10-hustler-build.html Is a link to my build |
Get the TCS mount. It works much better. http://www.tcscrawlers.com/TCS-Servo...t-p-16519.html I made my own. http://i133.photobucket.com/albums/q...-2-07_4287.jpg Good Luck!"thumbsup" |
This is my hustler check out the dig servo mount worked great "thumbsup". http://www.rccrawler.com/forum/showt...y+south+hustla |
Quote:
|
Quote:
|
Well, The final servo plate was cut out of carbon fiber and I used bigger zip ties. |
Quote:
I angle ground the plate to get it to fit in there. I have very little holding the bottom of my plate, but its in there really good and works great. To fit the stock cover on the tranny, you need to cut the bottom off. Good Luck"thumbsup" |
All times are GMT -6. The time now is 01:00 PM. |
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Content Relevant URLs by vBSEO ©2011, Crawlability, Inc.
Copyright 2004-2014 RCCrawler.com