| |
12-27-2007, 09:45 PM
| #1 |
| Rock Stacker Join Date: Oct 2007 Location: a house
Posts: 95
|  hustler+r2d
ok i got a hustler and i orderd a r2d tranny, but the mount that hooks on to the tranny the the servo mount hooks to is just over 1/8 inch too wide to fit inside the chassis if this is normal, how are people getting the mount into the chassis thanks bigdog |
|  |
| Sponsored Links | |
| | |
|
12-28-2007, 01:57 PM
| #2 |
| Pebble Pounder Join Date: Jul 2007 Location: Sachse TX
Posts: 145
|
You have to grind some material off each side of the bracket to get it to fit. Grind a little and test fit, grind a little and test fit. It will work. Axial AX-10 Hustler Build Is a link to my build |
|
| |
|
12-28-2007, 05:11 PM
| #3 |
| I wanna be Dave Join Date: Dec 2006 Location: In Cali.
Posts: 4,109
|
Get the TCS mount. It works much better. http://www.tcscrawlers.com/TCS-Servo...t-p-16519.html I made my own.  Good Luck!  |
|
| |
|
12-28-2007, 05:34 PM
| #4 |
| ΜΟΛΩΝ ΛΑΒΕ   Join Date: Dec 2006 Location: In tha Bush of Louisiana
Posts: 4,343
| |
|
| |
|
12-28-2007, 07:17 PM
| #5 | |
| RCC Addict Join Date: Jul 2006 Location: barstow
Posts: 1,303
| Quote:
| |
|
| |
|
12-28-2007, 07:24 PM
| #6 | |
| RCC Addict Join Date: Jul 2006 Location: barstow
Posts: 1,303
| Quote:
| |
|
| |
|
12-28-2007, 07:35 PM
| #7 |
| ΜΟΛΩΝ ΛΑΒΕ Join Date: Dec 2006 Location: In tha Bush of Louisiana
Posts: 4,343
|
Well, The final servo plate was cut out of carbon fiber and I used bigger zip ties.
|
|
| |
|
12-28-2007, 09:48 PM
| #8 | |
| I wanna be Dave Join Date: Dec 2006 Location: In Cali.
Posts: 4,109
| Quote:
I angle ground the plate to get it to fit in there. I have very little holding the bottom of my plate, but its in there really good and works great. To fit the stock cover on the tranny, you need to cut the bottom off. Good Luck | |
|
| |
 |
| |
Linear Mode
