01-14-2013, 05:28 PM | #1 |
RCC Addict Join Date: May 2010 Location: So. Charleston. Wv
Posts: 1,221
| MIP/Overunder question
I know im going to catch hell for this but im runnin mip shafts an got set of over under gears. i done some searching before found it but i cant seem to find but saw where someone used a traxxas set screw pin for MIP's an pin to go through pinion hole..... ready to catch hell in 3 2 1 |
Sponsored Links | |
01-14-2013, 06:45 PM | #2 |
Quarry Creeper Join Date: Jan 2011 Location: Waterford MI
Posts: 359
| Re: MIP/Overunder question
So you need too know the part number for the pin? Axial a part number for that pi. Is axa0286. I hope this helps!
|
01-14-2013, 06:50 PM | #3 |
Quarry Creeper Join Date: Jul 2012 Location: Alpharetta, GA
Posts: 416
| Re: MIP/Overunder question
I used Traxxas TRA5189 on my MIPs
|
MIP/Overunder question - Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
MIP drive shaft Question..... | hatefulboy | Axial AX-10 Scorpion | 4 | 09-04-2012 12:07 PM |
MIP length question | brianw | Axial SCX-10 | 3 | 08-23-2011 10:18 PM |
MIP spline question..... | bob1961 | General Crawlers | 3 | 02-24-2011 07:26 PM |
MIP drive shaft question | barebones | Axial AX-10 Scorpion | 9 | 11-01-2009 02:42 AM |
MIP axle question. | TYZWK | HPI Wheely King | 6 | 11-21-2008 06:25 AM |
| |