| |
| |||||||
 |
| | LinkBack | Thread Tools | Display Modes |
11-23-2017, 12:08 AM
| #1 |
| Quarry Creeper Join Date: Dec 2013 Location: Swartz Creek ~ MI
Posts: 227
|  Pro-Line Fuel Cell & NOS Bottle
I want to buy this Pro-Line Fuel Cell & NOS Bottle 1:10th scale accessory set. For my R/C Scaler but there is no detail plan of how to set it up. I want to set it up in my coldbuster bodied scaler towards the front of the bed just under the rear window. Where the barrel tank is now. In the last pic. ~ That is an old pic before the new repaint but sill the same truck bed setup. I found a pic of one scaler with this set / setup, And a real setup in a trunk of a car. If you you could post some pics of how you have yours setup that would be helpful, Thank You !!!     |
|  |
| Sponsored Links | |
| | |
|
11-23-2017, 10:25 AM
| #2 |
| Rock Stacker Join Date: Nov 2011 Location: NEPA
Posts: 65
| Re: Pro-Line Fuel Cell & NOS Bottle
Theoretically, those two solenoids should be under the hood, but I know that's tough with RC (no opening hood).
|
|
| |
|
11-24-2017, 04:23 AM
| #3 | |
| Sinking with the ship   Join Date: Mar 2005 Location: El Capitan...sole survivor and sinking fast
Posts: 8,864
| Re: Pro-Line Fuel Cell & NOS Bottle Quote:
OP, typically on a real fuel system you'd want both the fuel pumps as close to the fuel cell as possible. as far as the regulator goes, it depends on the fuel system, if its carb'd you'd want before it feeds the carbs, so it would inline after the dual pump set up. If its EFI, then you generally regulate the return side...not always but generally. The nitrous bottle would have just one line running to under the hood to the solenoids which pro line doesnt give you but could easily be scratch built out of some styrene | |
|
| |
|
12-14-2017, 12:38 AM
| #4 |
| Quarry Creeper Join Date: Dec 2013 Location: Swartz Creek ~ MI
Posts: 227
| Re: Pro-Line Fuel Cell & NOS Bottle
I got my Fuel Cell & NOS Bottle installed, I think it added a little more scale look to the bed of the truck. PS: I am going to cover up the Roll Bar metal tabs that mount it to the bottom of the bed, With a scale battery on one side and a milk crate on the other side. Or a battery on both sides, ether way them ugly metal tabs will be covered up.   Last edited by Stomper Fan 777; 12-14-2017 at 01:07 AM. |
|
| |
|
12-14-2017, 08:21 AM
| #5 |
| RCC Addict Join Date: Dec 2014 Location: So Cal
Posts: 1,005
| Re: Pro-Line Fuel Cell & NOS Bottle
Where is the aux/supplemental fuel cell? You're running alky as the fuel for the oxidizer, in order to make that big HP shot, right? Throw a bottle warmer on that while you're at it! Cleaner looking with the new stuff.
|
|
| |
|
| Thread Tools | |
| Display Modes | |
| |
Linear Mode
